THE SUPPLIES YOU WILL NEED TO BAND A TREE
Blackhawk Hardware has all the supplies and knowledge you will need to band and protect your trees against Cankerworms. If you would like to speak with an expert about your lawn care needs, don’t hesitate to call us at 704.525.2682 or stop by Blackhawk and and have one of our extremely knowledgeable Lawn and Garden associates assist you with any questions.
HOW TO BAND A TREE
Step 1 – Install a strip of cotton or insulation around the tree at least three feet from the ground and below the lowest limb.
Step 2 – Position a band of roofing felt over the strip and attach it to the trees with the staple gun. Avoid using staples on small, young or thin-barked trees. Instead use electrical tape to hold the bands.
Step 3 – Using disposable gloves and a putty knife, put a film of Tanglefoot (glue) directly on the band, approximately 1/8″ thick.
Tips
- In order to be effective, all trees need to be banded. The worms feed on all types of trees. Large trees (taller than a two-story house) are the main focus of banding. Small trees can also be banded.
- The glue, Tanglefoot, should be applied after most of the leaves have fallen. If the trap becomes clogged with leaves or insects, you should clean it, renew the Tanglefoot or install a new trap. The bands should be removed during the first week of February.
- There are other banding products available at Blackhawk. Come in and let our experts help you choose the products that will suit your needs.
